# EPOXY SELF-LEVELING MORTAR RAINBOW PAINTS ## Product Code NO.1029C ## Type Self-leveling resin mortar formulated with epoxy resin, hardener and graded silica sand. ## Application Floor surfacing for heavy machinery plants, chemical factories, electronic tech factories, assembly workshops, laboratories, GMP pharmaceutical plants, operating rooms, wastewater treatment plants, ramps and parking garages. ## Properties 1. Strong adhesion to cement and steel substrates, no cracking or peeling 2. Excellent mechanical performance, withstands heavy stacking loads and rolling of large vehicles 3. Resistant to a wide range of acids, alkalis, solvents and other chemicals 4. Free of deformation under drastic temperature fluctuations 5. Good sanding and leveling performance, no sand residue sticking to abrasive cloth 6. Self-leveling after trowel application without floating sand; solvent-free topcoat can be applied directly without intermediate sanding layer, saving labor and construction time ## Specification Data - Color: Natural color, custom specified color - Specific Gravity: ≥1.1 Kg/L (resin mixture) - Viscosity: Paste consistency (mixed compound, 25°C) - Drying Time - Tack-free: Within 6 hours - Hard dry: Within 12 hours - Full cure: 7 days (25°C) - Dry Film Thickness: 1~3 mm - Theoretical Coverage: 3.5 Kg/㎡ @ 2 mm dry film - Recoating Interval: Minimum 12 hours - Mix Ratio: Base : Hardener : Graded Silica Sand = 22.5 : 7.5 : 50 (by weight) (or follow factory designated ratio) - Pot Life: 30 minutes (mixed mortar at 25°C) - Thinner: No.1005 Rainbow Thinner (SP-12) - Thinner Dosage: Dilution prohibited; only for cleaning tools - Compatible Topcoats: No.1001 Rainbow Epoxy Topcoat (EP-04), No.1015 Solvent-Free Anti-Static Topcoat, No.1098W Conductive Primer - Storage Stability: Minimum 1 year under normal storage ## Application Method Manual trowel application ## Construction Precautions ⚠️ 1. Mix base and hardener uniformly in specified ratio first, then add graded silica sand and stir thoroughly. 2. Fully remove all surface contaminants including moisture, grease, sludge and dust from substrates. 3. Avoid construction on rainy days or when ambient relative humidity exceeds 85%RH. Ensure full surface dryness for damp substrates. 4. Cement floor moisture content must be below 12%; flame forced drying is required if moisture exceeds 12%. 5. Cement floor compressive strength shall be at least 150 Kg/cm², free of oil stains, loose sand grains and dust. 6. Wear gloves during construction to prevent direct skin contact. 7. The listed mixing ratio is standard. Contact our technical department for customized requirements.