# EPOXY WATER TANK COATING HB RAINBOW PAINTS ## Product Code No.1017 (EP-07) ## Type Two-component potable water tank topcoat refined with epoxy resin, special hardener and water-resistant pigments. ## Application Ideal topcoat for drinking water tanks, fresh water tanks, aquaculture tanks; also suitable for cargo holds, oil tanks and ballast tanks. ## Properties 1. Single spray coat achieves 100 μm thick dry film 2. Hard and flexible coating film with superior abrasion resistance 3. Excellent resistance to water, oil and various chemicals 4. Outstanding anti-corrosion performance 5. No contamination to drinking water ## Specification Data - Gloss: High Gloss - Color: White, Grey or custom specified colors - Specific Gravity: 1.40 kg/L for grey shade, varies by other colors (mixed paint) - Viscosity: 70~85 KU (mixed paint, 25°C) - Drying Time - Surface dry: Within 2 hours - Hard dry: Within 10 hours - Full cure: 7 days (25°C) - Film Thickness: Wet film 180 μm, Dry film 100 μm - Theoretical Coverage: 5.5 ㎡/L, 4.0 ㎡/kg (varies by color) - Recoating Interval: Min. 20 hours, Max. 5 days (25°C) / Max. 3 days (30°C) - Mix Ratio: As marked on each bucket - Volume Solids: Above 55% (mixed paint, varies by color) - Pot Life: 8 hours (mixed paint at 20°C) - Heat Resistance: Continuous 93°C, Intermittent 121°C - Thinner: No.1005 Rainbow Thinner (SP-12) - Thinner Dosage: 5~15% (excluding tool cleaning) - Compatible Primers: - Steel Substrate: No.1075 Rainbow Zinc Phosphate Anti-Corrosion Primer - Concrete Substrate: No.1073 Transparent Cement Primer, No.1002 White Primer - Storage Stability: Minimum 3 years under normal storage ## Application Methods Brush Coating, Airless Spray, Roller Coating ## Construction Precautions ⚠️ 1. Mix base and hardener evenly in specified ratio, let stand for 10~20 minutes induction time before use. 2. Fully remove all surface contaminants including moisture, grease, sludge, dust, rust and corrosive salts from substrates. 3. Avoid construction when temperature below 10°C, raining or ambient relative humidity over 85%RH. Fully dry damp surfaces prior to coating. 4. Clean all coating equipment immediately after use. 5. Ensure sufficient ventilation during construction inside tanks or pits. 6. Sand the coating surface if recoating interval exceeds specified time to improve interlayer adhesion. ## Note All data provided in this product datasheet are derived from internal laboratory tests for construction design reference only. Actual performance varies subject to different construction environments. This document does not constitute any legally binding warranty or statement from the manufacturer. Contact our technical department for clarification of any uncertainties.